/wp-content/uploads/2025/08/Flux_Schnell_a_lush_3d_render_of_Futuristic_space_age_vector_l_3-300x300.jpg How Much Water Do You Need Stored for Wildfire Defense? - Wildfire Watchdog

Folks spend a lot of time asking me about pumps. Fewer ask about the water. But a 150 GPM pump with an empty tank is just a loud paperweight. Winter is a good time to sort out your storage, before fire season has you scrambling.

Do the math on your tank

A pump moves water a lot faster than most people expect. At full output, 150 gallons a minute drains a 2,500-gallon tank in under 17 minutes. You won’t run it wide open the whole time, but it shows why tank size matters.

A rough way to think about it:

  • One or two sprinklers on the roof and the closest fuels use a lot less than a hose crew would.
  • Hand-held hose lines on spot fires pull the most water, so plan for those in short bursts.
  • Add up your sprinkler flow rates and your hose use, then figure how many minutes you want to run. That gives you gallons.

Ask your local fire district what they recommend for your property. Many rural districts have guidelines for static water supplies, and some will tell you what fittings their engines can connect to.

Tanks, ponds, and what to avoid

Poly tanks are the usual choice. They’re affordable, they don’t rust, and you can get them in sizes from a few hundred gallons to several thousand. Some things I’ve learned from years of rural work:

  • Put the tank where you can get to it. If you have to cross brush or a steep slope to reach it, you’ve made your job harder.
  • Keep it clear of fuel. Don’t set it right up against heavy timber or a woodpile. Poly will melt.
  • Use a bury or a shade cover if you can. It keeps algae down and the tank lasts longer.
  • Ponds and creeks work, but check your water rights and keep your intake screened. Debris will clog a pump fast.

Keep it full through the winter

In Central Oregon, a tank that’s completely full is better off in a freeze than one that’s half empty, since ice forms at the surface and a full tank has less air space to work with. But the fittings, valves, and hose are what split. Drain the exposed plumbing, or wrap and insulate it. Leave a little slack in your suction line so ice doesn’t crack a fitting.

Check the level every month. Slow leaks at a bulkhead fitting or a cracked valve can drain a tank over a couple of months, and you won’t know until you need it. A sight gauge or a simple marked stick helps.

Know when something goes wrong

This is the part that bothers me most. Most people aren’t at home when a fire is coming. You might be at work, or on the other side of the pass. Our remote-start wildfire pump, the Dry Lightning 3000, runs a Honda iGX390 engine and puts out up to 150 GPM. You start and stop it from a phone app from anywhere. It also alerts you if the pump stops running, such as when it runs out of gas, or when the water tank gets low. That way you know what’s happening at home while you’re away.

Whatever system you use, the principle is the same. Know your water level and your fuel level without having to drive out and look.

One thing to do this week

Go out to your tank and check the level. Write down how many gallons you have, then work out how many minutes of sprinkler or hose flow that gets you. If the answer is under an hour, start pricing a bigger tank or a second one. Then drain or insulate any exposed plumbing before the next hard freeze.